Quarterly Journal of the Japan Welding Society
Vol.15 No.2 May 1997
Contents
(Page)
- (234)
- Residual Stress Measurement of Near Interface Region in Silicon Nitride
and Stainless Steel Brazing Joint
- Nobuyuki FUJII, Kinichi KANNO and Shigeru KOZAKI
- (241)
- Reaction and Brazeability of Magnesium containing Aluminum Alloys with
Non-corrosive Flux
- Tadashi TAKEMOTO, Akira MATSUNAWA and Toshihiro SHIBUTANI
- (247)
- Research on the Locus and the Velocity of Spatter in Shielded Metal
Arc Welding
- Kouichi TANAKA, Yoshihiro INOSE, Susumu IDA, Nobuhiko NISHIWAKI and
Sankei HORI
- (254)
- Reduction of Spatter Generation in High Speed Pulsed MAG Welding
- Hitoshi MATSUI and Hiroshi SUZUKI
- (259)
- Plasma structures in Ar-H２ mixed gas tungsten arcs determined by some
spectroscopic measurements
- Kazuo HIRAOKA
- (267)
- The Formation of NiCrAlY Laser Cladding with Preplaced Method
- Hiroyuki IWAMOTO, Takashi SUMIKAWA, Kouichi NISHIDA, Minoru NISHIDA
- and Takao ARAKI
- (272)
- Dynamic Characteristics of Arc Sensor in GMA Welding in Dip Transfer
Mode
- ―A Study of the Improvement of the Sensitivity and the Reliability
of Arc Sensor in GMA Welding
- (3rd Report)―
- Masao USHIO and Wenjie MAO
- (281)
- Epitaxial Growth and Phase Selection of Austenitic Stainless Steel
Weld Metals near Fusion Boundaries
- ―Study on Solidification and Subsequent Transformation of Cr-Ni Stainless
Steel Weld Metals
- (Report 3)―
- Hiroshige INOUE, Toshihiko KOSEKI, Shigeru OHKITA and Masao FUJI
- (292)
- Solidification and Transformation Behavior of Cr-Ni Stainless Steel
Weld Metals with Ferritic Single Phase
- Solidification Mode
- ―Study on Solidification and Subsequent Transformation of Cr-Ni Stainless
Steel Weld Metals
- (Report 4)―
- Hiroshige INOUE, Toshihiko KOSEKI, Shigeru OHKITA and Masao FUJI
- (305)
- Effect of Massive Transformation on Formation of Acicular Structure
in Austenitic Stainless Steel Weld Metal
- Solidified as Ferritic Single Phase
- ―Study on Solidification and Subsequent Transformation of Cr-Ni Stainless
Steel Weld Metals
(Report 5)―
Hiroshige INOUE, Toshihiko KOSEKI, Shigeru OHKITA and Masao FUJI
- (314)
- Prevention of HAZ Cracking in Corner Joint by Submerged Arc Welding
with High Heat Input
- Tsunemi WADA, Toshio TERASAKI and Satoshi IGI
- (321)
- Effect of Base Metal Grain Boundary on TLP-Bonding Phenomena of CMSX-2
- ―Transient Lipuid Phase Bonding of Ni-Base Single Crystal Superalloy
(Report 3)―
- Kazutoshi NISHIMOTO, Kazuyoshi SAIDA, Daeup KIM, Satoru ASAI and Yasuhiro
FURUKAWA
- (330)
- Metallizing of Aluminum Nitirde by Ion Plating Technique
- ―Bonding of Aluminum Nitride to Copper using Surface Modification
Technique (Report 2)―
- Kazuyoshi SAIDA, Kazutoshi NISHIMOTO, Tetsuya FUJIMOTO, Katsuyuki TANAKA
- and Yasuhiro FUKAYA
- (338)
- Improvement of Sensitization in Weld Metals of Austenitic Stainless
Steels by Laser Surface Melting Treatment
- ―Study on Low Temperature Sensitization in Weldments of Austenitic
Stainless Steels and Its Improvement by Laser Surface Melting Treatment
(Report 3)―
- Kazutoshi NISHIMOTO, Hiroaki MORI anb Tatsuya YAMAMURA
- (344)
- Improvement in Joint Properties at Elevated Temperature by Optimizing
the Chemical Composition of Insert Metal
- ―Transient Liquid Phase Bonding of HP Alloy (Report 2)―
- Kazutoshi NISHIMOTO, Kazuyoshi SAIDA, Akihisa MOCHIZUKI, Masahiro INUI
- and Makoto TAKAHASHI
- (352)
- Interfacial Phases in Diffusion-Bonded Joints of Al-X Alloys (X＝Mg,
Si, Mn, Zn, Cu)
- ―Diffusion-Bonding Mechanism of Al Alloys by Transmission Electron
Microscopy (Report 5)―
- Keiko KOTANI, Jae Pil JUNG, Kenji IKEUCHI and Fukuhisa MATSUDA
- (359)
- High-Cycle Fatigue Life Properties of MCrAlY Alloy Coated Systems
- ―A Study for Life Properties of High-Temperature Protective Coated
Systems (Report 2)―
- Yoshiyasu ITOH, Masahiro SAITOH and Yutaka ISHIWATA
- (365)
- Elevated Temperature Fatigue Crack Propagation Properties of Butt Welded
Joints
- Naoyuki SUZUKI, Akihiko OHTA and Yosio MAEDA
- (370)
- Cryogenic Fracture Toughness and Temperature Rise of Thick Section
Weldment in Forged JJ1 Type Austenitic
- Stainless Steel Plate
- Yasuhide SHINDO, Tomotaka TAKAHASHI, Katsumi HORIGUCHI, Tomoyuki KOBORI
- and Kazuaki SANADA
- (376)
- Characteristics of Au-Sn Microsoldered Layer of the TCP Outer Lead
Connection
- ―A Study on Microjoining of Leadframe for LSI Package (No. 4)―
- Mamoru MITA and Toyohiko KUMAKURA
- (383)
- Effect of Mold Resin on Reliability in Gold-Aluminium Bonding
- Yasuhide OHNO and Isao SHIMIZU
- (389)
- Society Announcements
jws-ym@kt.rim.or.jp